If the equipment is not functioning correctly in a TILE classroom, resetting the Crestron MPS-300/DMPS-300-C switcher may resolve the issue. While the MPS-300 is pictured below, this process is identical for the DMPS-300-C.

Equipment Rack from PH 216 TILE. red circle around part of the tech.

First, locate the device in the instructor's podium. It will be marked "MPS-300" on the bottom right corner of the panel.

Crestron MPS-300

There are two reset buttons, "HW-R" and "SW-R". A hardware reset is usually preferred, so use a pen or paperclip to press and hold the "HW-R" button for about 10 seconds. When the button is released, the system will reboot. This may take a minute to complete.

 

 

Once the cycle has completed, the system should function as expected.

Article number: 
101212
Last updated: 
November 30, 2016
Category: